SPL has developed a circuit design that combines natural sound characteristics and the highest level of technical performance. SPL’s Auto Dynamic De-Esser monitors the S-frequency spectrum and automatically detects the sibilant frequencies. The de-ess bandwidth is set so narrowly around the range of the sibilance that neighboring frequencies remain unaffected. Input processed via this frequency band is mixed back into the main signal phase-inverted so that only the S-sounds are cancelled where the S-reduction controller determines the intensity of the phase-cancelled mix. The result is a neutral, unobtrusive and extremely effective de-essing process. Even at high S-reduction values the de-essing has a negligible effect on the character and timbre of the voice.

Rounding out the amazingly simple control system is an automatic threshold-adjusting function. Differences in the input level caused by the varying distance to the mic, are compensated for automatically. This ensures even De-Essing independent of signal level so any necessary compression may be applied post the de-esser.

SPECIFICATIONS

• Instrumentation amplifier, electronically balanced (differential), transformerless
• Nominal input level +6 dB
• Input impedance =22 kΩ
• Output impedance < 600Ω
• Max. input level +24 dBu
• Max. output level +22.4 dBu
• Minimum load 600Ω
• Relay hard bypass / power fail safety
• Frequency response 20 Hz-50 kHz (50kHz= -3dB)
• Common mode rejection > -80 dBu @1kHz
• Total harmonic distortion 0.002% @ 1 kHz
• Signal-to-noise ratio -93 dBu (CCIR 468-3)
• Signal-to-noise ratio -98 dBu (A-weighted)

  Power supply

• Toroidal transformer 15 VA
• Fuses (230/115 V) 315 mA/630 mA
• GND lift switch, voltage selection switch 115 V / 230V

  Dimensions

• Standard EIA 19”/IHE 482 x 44 x 237mm
• Note: 0 dBu = 0.775 V

Back to top

MANUALS & PDFs

SPL Electronic Auto Dynamic De-esser Manual Adobe pdf

SPL Electronics Auto Dynamic De-esser Product Info Adobe pdf