Size: 1U case 270 mm deep

Weight: 5.5 kgs

Input

Connector: 2 off XLR and 1/4 inch jack combo socket

Impedance: 10k electronically balanced

Wiring:
•Pin 1 (Sleeve) ground
•Pin 2 (Tip) hot
•Pin 3 (Ring) cold

Gain: -14 dBu to +6 dBu

Output

Left and right monitor outputs: 2 off XLR3 type male left & right

Impedance: <100 ohm electronically balanced wiring Pin 1 ground, Pin 2 hot, Pin 3 cold

Sub Bass output: 1 pair binding posts

Filters

Left & right input summed to sub output

Subsonic/High pass: -3dB @ 14 Hz, 24dB/oct or -3dB @ 28 Hz, 24dB/oct (set by internal jumper)
Low Pass: -3dB @ 40 Hz to 135 Hz, externally adjustable @ 24db /oct or full range on CH A

Left right input to left & right output

Ultra sonic -1dB @ 100k

High pass: -3dB @ 40 Hz to 135 Hz, externally adjustable @ 24db /oct or full range on CH A

Power amplifier

> 210W rms continuous
T.H.D.: < 0.03% at levels up to 1dB below clip, 20 Hz - 120 Hz typ 0.005% @ 20W rms 100 Hz
Hum + Noise: < -100 dB referred to clip

Controls

Crossover Frequency 40 - 135 Hz, front panel pot
Test (Band limited pink noise), front panel recessed switch (LED indicates when on)
Sub bass bypass, front panel switch (LED indicates when bypassed)
Sub Gain -14 to +6, front panel pot (Sub level indicated with LED Meter)
Sub Phase, front panel pot
Sub Polarity, front panel recessed switch (LED indication for positive and negative polarity)
Lower, front panel switch
Left channel sub filter bypass, rear mounted recessed switch
Subsonic filter 14 or 28 Hz, internal jumpers

Power requirements

Voltage: Set by internal plug: nominal 115V or 230V @ 50-60Hz AC.30V setting: Min 160V (restrictedoutput power):
Max 255V. 15V setting: Min 80V (restricted output power): Max 127V

Consumption:
•Quiscent: 30W.
•Typical use: 50W. Max: 200W.

Note 0 dBu = 775 mV into open circuit