The SB10R is a powered 10" subwoofer designed to complement all of the full-range monitors in the S-Series. The SB10R will extend the system frequency response down to 20 Hz and increase the system's maximum spl.
The filter bypass on the left channel optimises the SB10R's performance when it is used as a dedicated LFE monitor in a multi-channel system. With the 2-in 2-out bass management, a single SB10R can reinforce a stereo pair of full range cabinets.
A long throw 10" cast chassis driver is mounted in a tuned cabinet constructed of ash veneered 26 mm MDF.
Tradition is broken in that the matched 215W RMS amplifier and 2-channel SB10R controller are housed in a separate, single 1U rack space unit. Due to this Remote Power, the electronics do not suffer the adverse effects caused by the LF vibrations that are created by the drive unit. Calibration and operation of the SB10R controller are easily achieved in comfort with the unit sited close to hand.
- Size (WxHxD): 24.3(w) x 13.1(h) x 11.4(d) inches
- Weight: 43.6 lb
- Drivers: 1 x 250mm (10")
- Input Sensitivity: Dependent upon controller setting
- Frequency response: Set by controller
- Input connector: 1 pair gold plated binding posts
- Input impedance: 3.3 Ω
- Size: 1U case 10.6" deep
- Weight: 12.1 lb
- Input connector: 2x XLR + 1/4" combo jack
- Gain: -14dBu to +6 dBu
- Outputs:
- L & R Monitor Outputs: XLR
- Sub Bass Output: 1 pair binding posts
- Filters:
- L & R input summed to sub output
- Subsonic/High pass: -3dB @ 14 Hz, 24dB/oct or -3dB @ 28 Hz, 24dB/oct (set by internal jumper)
- Low Pass: -3dB @ 40 Hz to 135 Hz, externally adjustable @ 24db /oct or full range on CH A
- Left right input to left & right output
- Ultra sonic: -1dB @ 100k
- High pass: -3dB @ 40 Hz to 135 Hz, externally adjustable @ 24db /oct or full range on CH A
- Power amplifier:
- Output: > 210W RMS continuous
- T.H.D.: < 0.03% at levels up to 1dB below clip, 20 Hz - 120 Hz typ 0.005% @ 20W rms 100Hz
- Hum + Noise: < -100dB referred to clip
- Controls:
- Crossover frequency 40-135 Hz
- Test (band limited pink noise)
- Sub bass bypass
- Sub gain -14 to +6
- Sub phase
- Sub polarity
- Left channel sub filter bypass
- Subsonic filter, 14 or 28 Hz
Home | Gear | This Just In! | Swag | The Black Pages
|
|
Unauthorized reproduction is prohibited by law, subject to criminal prosecution, and just not cool.
Mercenary© US Pat & TM off.